Diodes Inc Fixed Shunt Voltage Reference 3V ±1.0 % 3-Pin SOT-23, LM4040D30FTA

RS kataloški broj:: 165-8407robna marka: DiodesZetexProizvođački broj:: LM4040D30FTA
brand-logo
Prikaži sve u Voltage References

Tehnička dokumentacija

Tehnički podaci

Reference Type

Fixed

Pin Count

3

Minimum Operating Temperature

-40 °C

Mounting Type

Surface Mount

Topology

Shunt

Maximum Operating Temperature

+125 °C

Nominal Voltage

3V

Initial Accuracy

±1.0 %

Width

1.4mm

Height

1.02mm

Maximum Output Current

15mA

Length

3.04mm

Package Type

SOT-23

Dimensions

3.04 x 1.4 x 1.02mm

Zemlja podrijetla

China

Detalji o proizvodu

Tubular

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Zamisliti. Stvoriti. Surađivati

PRIDRUŽITE SE BESPLATNO

Bez skrivenih naknada!

design-spark
design-spark
  • Preuzmite i koristite naš softver DesignSpark za svoje PCB i 3D mehaničke dizajne
  • Pregledajte i doprinesite sadržaju internet stranice i foruma
  • Preuzmite 3D modele, sheme i otiske s više od milijun proizvoda
Kliknite ovdje kako biste saznali više

Informacije o stanju skladišta trenutno nisu dostupne.

Provjerite ponovno kasnije.

Informacije o stanju skladišta trenutno nisu dostupne.

KM 0,735

Each (On a Reel of 3000) (bez PDV-a)

KM 0,86

Each (On a Reel of 3000) (s PDV-om)

Diodes Inc Fixed Shunt Voltage Reference 3V ±1.0 % 3-Pin SOT-23, LM4040D30FTA

KM 0,735

Each (On a Reel of 3000) (bez PDV-a)

KM 0,86

Each (On a Reel of 3000) (s PDV-om)

Diodes Inc Fixed Shunt Voltage Reference 3V ±1.0 % 3-Pin SOT-23, LM4040D30FTA
Informacije o stanju skladišta trenutno nisu dostupne.

Zamisliti. Stvoriti. Surađivati

PRIDRUŽITE SE BESPLATNO

Bez skrivenih naknada!

design-spark
design-spark
  • Preuzmite i koristite naš softver DesignSpark za svoje PCB i 3D mehaničke dizajne
  • Pregledajte i doprinesite sadržaju internet stranice i foruma
  • Preuzmite 3D modele, sheme i otiske s više od milijun proizvoda
Kliknite ovdje kako biste saznali više

Tehnička dokumentacija

Tehnički podaci

Reference Type

Fixed

Pin Count

3

Minimum Operating Temperature

-40 °C

Mounting Type

Surface Mount

Topology

Shunt

Maximum Operating Temperature

+125 °C

Nominal Voltage

3V

Initial Accuracy

±1.0 %

Width

1.4mm

Height

1.02mm

Maximum Output Current

15mA

Length

3.04mm

Package Type

SOT-23

Dimensions

3.04 x 1.4 x 1.02mm

Zemlja podrijetla

China

Detalji o proizvodu

Tubular

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Zamisliti. Stvoriti. Surađivati

PRIDRUŽITE SE BESPLATNO

Bez skrivenih naknada!

design-spark
design-spark
  • Preuzmite i koristite naš softver DesignSpark za svoje PCB i 3D mehaničke dizajne
  • Pregledajte i doprinesite sadržaju internet stranice i foruma
  • Preuzmite 3D modele, sheme i otiske s više od milijun proizvoda
Kliknite ovdje kako biste saznali više