Vishay2.8 V Green LED PLCC 2 SMD, VLMG31L1M2-GS08
Tehnička dokumentacija
Detalji o proizvodu
Grasslin 300W Transformers
This Grasslin 300 watt transformer has been professionally designed to supply 12 volts to outdoor garden lights, submersible fixtures and pool lights. The transformer features built in circuit protection which disconnects the power in case of overload.
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Informacije o stanju skladišta trenutno nisu dostupne.
Provjerite ponovno kasnije.
KM 0,757
Each (Supplied on a Reel) (bez PDV-a)
KM 0,886
Each (Supplied on a Reel) (s PDV-om)
Proizvodno pakovanje (kolut)
50
KM 0,757
Each (Supplied on a Reel) (bez PDV-a)
KM 0,886
Each (Supplied on a Reel) (s PDV-om)
Proizvodno pakovanje (kolut)
50
Tehnička dokumentacija
Detalji o proizvodu
Grasslin 300W Transformers
This Grasslin 300 watt transformer has been professionally designed to supply 12 volts to outdoor garden lights, submersible fixtures and pool lights. The transformer features built in circuit protection which disconnects the power in case of overload.
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.