McLennan Servo Supplies Planetary Gearbox, 5:1 Gear Ratio, 12 Nm Maximum Torque
Tehnička dokumentacija
Tehnički podaci
Gear Ratio
5:1
Gearbox Type
Planetary
Maximum Output Torque
12 Nm
Shaft Diameter
12.69mm
Diameter
57 mm
Overall Length
54mm
Detalji o proizvodu
Planetary Gearheads Series 57
0.9° and 1.8° Hybrid Stepper Motors
1.8° Step Angle,The motors are directly compatible with the stepper motor drive boards and also drive either motor (if required) in the half step mode i.e. 0.9° per step resulting in higher resolution, greater performance stability and faster stepping rates. Direction, velocity, acceleration/deceleration can be controlled by a stepper motor controller.,Applying the correct electrical pulse sequence to the windings of the stepper motor results in a 1.8° step angle rotation of the spindle (i.e. 200 steps per revolution). When correctly loaded and driven these motors will produce discrete output steps. The number of steps and speed of rotation are determined by the number of pulses and frequency of the input signal. This provides an ideal method for speed and position control. The motors are directly compatible with stepper motor drive boards.,Applications include:
Informacije o stanju skladišta trenutno nisu dostupne.
Proverite ponovno kasnije.
RSD 49.999
Each (bez PDV-a)
RSD 59.999
Each (s PDV-om)
1
RSD 49.999
Each (bez PDV-a)
RSD 59.999
Each (s PDV-om)
1
Kupujte na veliko
| količina | Jedinična cena |
|---|---|
| 1 - 4 | RSD 49.999 |
| 5+ | RSD 49.142 |
Tehnička dokumentacija
Tehnički podaci
Gear Ratio
5:1
Gearbox Type
Planetary
Maximum Output Torque
12 Nm
Shaft Diameter
12.69mm
Diameter
57 mm
Overall Length
54mm
Detalji o proizvodu
Planetary Gearheads Series 57
0.9° and 1.8° Hybrid Stepper Motors
1.8° Step Angle,The motors are directly compatible with the stepper motor drive boards and also drive either motor (if required) in the half step mode i.e. 0.9° per step resulting in higher resolution, greater performance stability and faster stepping rates. Direction, velocity, acceleration/deceleration can be controlled by a stepper motor controller.,Applying the correct electrical pulse sequence to the windings of the stepper motor results in a 1.8° step angle rotation of the spindle (i.e. 200 steps per revolution). When correctly loaded and driven these motors will produce discrete output steps. The number of steps and speed of rotation are determined by the number of pulses and frequency of the input signal. This provides an ideal method for speed and position control. The motors are directly compatible with stepper motor drive boards.,Applications include: