Tehnička dokumentacija
Tehnički podaci
Brand
STMicroelectronicsMotor Type
Brushed DC
Output Configuration
Dual Full Bridge
Maximum IGBT Collector Current
4A
Maximum Collector Emitter Voltage
46 V
Mounting Type
Surface Mount
Package Type
PowerSO
Maximum Operating Supply Voltage
46 V
Pin Count
20
Minimum Operating Supply Voltage
4.8 V
Inverter Power Rating
25W
Maximum Operating Temperature
+130 °C
Length
16mm
Height
3.6mm
Width
11.1mm
Dimensions
16 x 11.1 x 3.6mm
Minimum Operating Temperature
-25 °C
Detalji o proizvodu
L298 Dual Full Bridge Motor Driver
ST Microelectronics presents its L298 dual full bridge driver series. The L298 series from ST is an integrated high voltage, high current dual full bridge driver. These devices are specially designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that allow the L298 to be enabled or disabled independently of the input signals. The emitters of the lower transistors of each bridge are connected together, the corresponding external terminal can be used to connect an external sensing resistor. In addition, a supply input is provided so that the logic works at a lower voltage.
Motor Controllers & Drivers, STMicroelectronics
Informacije o stanju skladišta trenutno nisu dostupne.
Proverite ponovno kasnije.
P.O.A.
1
P.O.A.
1
Tehnička dokumentacija
Tehnički podaci
Brand
STMicroelectronicsMotor Type
Brushed DC
Output Configuration
Dual Full Bridge
Maximum IGBT Collector Current
4A
Maximum Collector Emitter Voltage
46 V
Mounting Type
Surface Mount
Package Type
PowerSO
Maximum Operating Supply Voltage
46 V
Pin Count
20
Minimum Operating Supply Voltage
4.8 V
Inverter Power Rating
25W
Maximum Operating Temperature
+130 °C
Length
16mm
Height
3.6mm
Width
11.1mm
Dimensions
16 x 11.1 x 3.6mm
Minimum Operating Temperature
-25 °C
Detalji o proizvodu
L298 Dual Full Bridge Motor Driver
ST Microelectronics presents its L298 dual full bridge driver series. The L298 series from ST is an integrated high voltage, high current dual full bridge driver. These devices are specially designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that allow the L298 to be enabled or disabled independently of the input signals. The emitters of the lower transistors of each bridge are connected together, the corresponding external terminal can be used to connect an external sensing resistor. In addition, a supply input is provided so that the logic works at a lower voltage.