ITT Cannon Male Dust Cap, Shell Size 16 IP67 Rated, Polymer
Tehnička dokumentacija
Tehnički podaci
Proizvođač
ITT CannonGender
Male
Shell Size
16
IP Rating
IP67
Panel Mount Fitting
Yes
Material
Polymer
Boja
Grey
Detalji o proizvodu
Dust Caps
Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.
Neptune
Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.
Informacije o stanju skladišta trenutno nisu dostupne.
Provjerite ponovno kasnije.
€ 9,35
komadno (u vrećici od 100) (bez PDV-a)
€ 11,688
komadno (u vrećici od 100) (s PDV-om)
100
€ 9,35
komadno (u vrećici od 100) (bez PDV-a)
€ 11,688
komadno (u vrećici od 100) (s PDV-om)
100
Tehnička dokumentacija
Tehnički podaci
Proizvođač
ITT CannonGender
Male
Shell Size
16
IP Rating
IP67
Panel Mount Fitting
Yes
Material
Polymer
Boja
Grey
Detalji o proizvodu
Dust Caps
Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.
Neptune
Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.