TE Connectivity Blue Polyolefin Solder Sleeve 18.54mm Length 0.76 → 1.52mm Cable Diameter
Tehnička dokumentacija
Tehnički podaci
Proizvođač
TE ConnectivityMinimum Cable Diameter
0.76mm
Maximum Cable Diameter
1.52mm
Sleeve Length
18.54mm
Material
Polyolefin
Voltage Rating
600 V
Minimum Operating Temperature
-5°C
Maximum Operating Temperature
+125°C
Boja
Blue
Series
D-110
Standards Met
ANSI J-STD-004, ANSI J-STD-006
Zemlja podrijetla
Mexico
Detalji o proizvodu
Solder Sleeves®
A one piece soldering system for jointing signal cables and terminating cable screens. The system consists of heat shrinkable sleeve containing a predetermined amount of fluxed solder and a thermoplastic sealing insert at each end. The solder sleeve is placed over the joint to be made and the sleeve is heated by a heat gun. The sleeve shrinks, the sealing inserts melt and flow and the solder starts to melt. Heating is continued until the solder is seen to fully melt and flow. Temperature range -55°C to +125°C.
Informacije o stanju skladišta trenutno nisu dostupne.
Provjerite ponovno kasnije.
€ 2,28
komadno (u pakiranju od 500) (bez PDV-a)
€ 2,85
komadno (u pakiranju od 500) (s PDV-om)
500
€ 2,28
komadno (u pakiranju od 500) (bez PDV-a)
€ 2,85
komadno (u pakiranju od 500) (s PDV-om)
500
Kupujte na veliko
| količina | jedinična cijena | Po pakiranje |
|---|---|---|
| 500 - 7000 | € 2,28 | € 1.140,00 |
| 7500 - 24500 | € 2,20 | € 1.100,00 |
| 25000+ | € 2,17 | € 1.085,00 |
Tehnička dokumentacija
Tehnički podaci
Proizvođač
TE ConnectivityMinimum Cable Diameter
0.76mm
Maximum Cable Diameter
1.52mm
Sleeve Length
18.54mm
Material
Polyolefin
Voltage Rating
600 V
Minimum Operating Temperature
-5°C
Maximum Operating Temperature
+125°C
Boja
Blue
Series
D-110
Standards Met
ANSI J-STD-004, ANSI J-STD-006
Zemlja podrijetla
Mexico
Detalji o proizvodu
Solder Sleeves®
A one piece soldering system for jointing signal cables and terminating cable screens. The system consists of heat shrinkable sleeve containing a predetermined amount of fluxed solder and a thermoplastic sealing insert at each end. The solder sleeve is placed over the joint to be made and the sleeve is heated by a heat gun. The sleeve shrinks, the sealing inserts melt and flow and the solder starts to melt. Heating is continued until the solder is seen to fully melt and flow. Temperature range -55°C to +125°C.