RS PRO Light Transformer, 230 to 240 V, 12 V
Tehnička dokumentacija
Tehnički podaci
Proizvođač
RS ProProduct Type
Light Transformer
Primary Voltage
230 to 240 V
Secondary Voltage
12 V
Minimum Load Requirement
30W
Maximum Operating Temperature
70°C
Minimum Operating Temperature
40°C
Sub Type
Dimmable Electronic Transformer
Termination Type
Screw
Mount Type
Screw
Width
49 mm
Depth
39mm
Length
190mm
Weight
205g
Standards/Approvals
EN 61347-2-2, VDE 0710-T14, EN 61347-1, EN 61547, EN 55015, EN 60598-1, EN 61000-3-2
Series
WOLF 150 - WX 150
Dimming Method
Trailing Edge
Maximum Operating Frequency
60Hz
Minimum Operating Frequency
50Hz
Zemlja podrijetla
Italy
Detalji o proizvodu
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Informacije o stanju skladišta trenutno nisu dostupne.
€ 43,23
€ 43,23 komadno (bez PDV-a)
€ 54,04
€ 54,04 komadno (s PDV-om)
1
€ 43,23
€ 43,23 komadno (bez PDV-a)
€ 54,04
€ 54,04 komadno (s PDV-om)
Informacije o stanju skladišta trenutno nisu dostupne.
1
Tehnička dokumentacija
Tehnički podaci
Proizvođač
RS ProProduct Type
Light Transformer
Primary Voltage
230 to 240 V
Secondary Voltage
12 V
Minimum Load Requirement
30W
Maximum Operating Temperature
70°C
Minimum Operating Temperature
40°C
Sub Type
Dimmable Electronic Transformer
Termination Type
Screw
Mount Type
Screw
Width
49 mm
Depth
39mm
Length
190mm
Weight
205g
Standards/Approvals
EN 61347-2-2, VDE 0710-T14, EN 61347-1, EN 61547, EN 55015, EN 60598-1, EN 61000-3-2
Series
WOLF 150 - WX 150
Dimming Method
Trailing Edge
Maximum Operating Frequency
60Hz
Minimum Operating Frequency
50Hz
Zemlja podrijetla
Italy
Detalji o proizvodu
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.