Igus 2 Hole, EFOM-20

Igus DryLin W Series Bearing Block, 3200N Static Load Rating, 45mm Carriage Length - WJ200UM-01-20

This bearing block provides guided linear motion support for industrial automation and mechanical systems, designed to run on compatible rails and carry carriage loads in constrained assemblies. It is intended for use where a compact slider carriage is required to transmit static loads while integrating with DryLin linear guide setups.

Features and Benefits:

• Static capacity 3200N delivers robust load support for assemblies
  Carriage constructed from die-cast zinc reduces wear under load
  Slider format enables smooth linear guidance with minimal maintenance
  Carriage width 42.5mm offers a narrow footprint for tight installations
  Accepts rails up to 82mm to support a range of guide profiles

Applications

• Suitable for pick-and-place gantry axis in automation cells
  Ideal for mounting sensors or actuators on linear stages
  Used with compact conveyor transfer systems in electronics lines
  Can be used for sliding fixtures in electrical panel assembly

What carriage length is provided for mounting requirements?

The block uses a 45mm carriage which offers a short mounting base for integrating brackets and fitted components.

What material considerations affect thermal and mechanical behaviour?

The carriage alloy is die-cast zinc, which provides dimensional stability and predictable expansion under temperature variations compared with some plastics.

Which rail widths will this block interface with?

It is compatible with rails having a nominal width of up to 82mm, allowing selection from a range of standard linear guide profiles.

How does the static load rating influence selection for stationary loads?

The 3200N static rating defines the maximum non-moving load the carriage can sustain without exceeding its static capacity, useful for specifying supports in stopped or parked conditions.

Notes

IGUBAL® bearings are designed to run with a clearance between the shaft and the inside diameter of the ball, to prevent the ball turning in the housing.